
White Galaxy

Attention
Daily Care and Cleaning
Depending on use, if countertops or floors lose their shine, become scratched, or develop stubborn stains that are difficult to remove, crystallization repair or even renovation/refinishing may be required.
3.1 Key Points for Daily Maintenance
1) Perform routine cleaning daily as needed:
a. Dust-mop or vacuum regularly to keep the stone surface clean. Sand and grit left on the stone act like sandpaper when people walk over it, so prevent serious damage to the stone surface.
b. For routine cleaning, use clean water, or a neutral cleaner mixed with water when needed, to mop the floor.
c. The floor may also be mopped daily with diluted K-1 solution at a dilution ratio of 1:150.
2) When needed, apply Lisheng professional sealer, Gaochen crystallizer, or Daolong DN528 crystallizer to the treated floor following the initial procedure, and spread it with a machine. For small areas, a hand polisher can be used to restore gloss; for large areas such as commercial floors or public transit areas, a crystallizing machine should be used.
3) Perform maintenance once a month. In low-traffic areas, once every 3 months is sufficient. Areas with less exposure to contamination, such as windowsills, can be maintained as needed.
Engineered Stone Daily Maintenance Notes
1) Do not allow prolonged contact with non-neutral substances. Strong acids and alkalis can corrode the stone surface.
2) For crystallization care, use neutral or weakly acidic, stable products.
3) Clean stone surfaces with a neutral or weakly alkaline cleaner, then rinse away all residue with water. Acidic cleaner residue will dull the stone surface.
4) Do not leave carpets or clutter covering the stone for long periods. Clean and change carpets regularly, and remove clutter promptly. Otherwise, excessive moisture can increase the stone's water content and cause stone deterioration.
5) Keep the surface thoroughly clean, remove spills immediately, and maintain good ventilation and dryness. Never use steel wool or other rough tools to clean the stone surface.
6) Apply protective treatment regularly; a high-quality sealer should ideally be applied once every 2 years.
7) When using a floor scrubber or automatic floor-cleaning machine, do not use a scrubbing brush. Use only yellow or white cleaning pads. The uneven pressure and hardness of a scrubbing brush can easily wear the floor.
