
Three-Sided View Wood-Burning Fireplace, 800 Folding Steel Interior









Details




Attention
1. The fireplace should ideally be installed during the rough-in stage of plumbing and electrical works.
2. When the Vuur-Drie fireplace achieves full combustion, the door can be raised completely to allow open-front burning.
3. An air intake vent with a minimum free area of 200 cm² must be provided at the base of the fireplace surround, and a heat release vent of at least 200 cm² must be placed near the top of the surround. The heat vent is recommended to be positioned 20–50 cm below the ceiling line.
4. Use firewood approximately 400 mm in length.
5. The fireplace relies on the natural draft created by the chimney height to expel smoke outdoors. Therefore, the horizontal run of the flue should generally not exceed 3 meters. Ensure the installation location allows for a convenient and effective flue exit.
6. If the fireplace is installed on a wooden floor, a non-combustible base such as a steel plate, stone slab, or tempered glass panel must be placed underneath to protect the floor from any sparks that may escape when the door is open.
7. Maintain a minimum clearance of 10 cm from the back of the fireplace to the rear wall. The temperature behind the unit is moderate, so conventional wall materials can be used on the rear wall. No combustible materials are permitted within 50 cm on either side of the fireplace, or within 1 meter directly in front of the appliance.
8. It is recommended to remove ash from the firebox after every 2–3 uses. The fireplace is equipped with an ash pan at the base and a dedicated tool for easy removal.
9. Burning wood with high moisture content may result in incomplete combustion, causing carbon particles to deposit on the glass. If the glass darkens, allow the fireplace to cool completely, then wipe it with a slightly damp cloth or paper towel dipped in a small amount of the fine white ash from the firebox—this cleans effectively without scratching. Do not use commercial glass cleaners, as their chemical ingredients may damage the ceramic glass surface.
10. When the fireplace is lit, the front glass surface can reach temperatures of 200–300°C (392–572°F). Avoid any contact. The fireplace comes with heat-resistant leather gloves; always wear them when operating the appliance.
11. To start the fire, we recommend using wax-based firelighters. Do not use liquid alcohol, accelerants, or other highly flammable materials to ignite the fireplace.
12. Always supervise children carefully when the fireplace is in use to prevent accidental contact, which may cause burns.
