
Butterfly Valley




Details





Attention
Paying of handmade enamel bricks and matters needing attention
1. Grassroots treatment-suitable for concrete walls, first of all, smooth out the concrete protruding from the wall. The concrete wall constructed with large steel molds should be chiseled and fully brushed with steel wires. Brush it once, and then water it to moisten it. If the wall is smooth, this link can be omitted.
2. Wall leveling and hoisting vertically and leveling-ensure that the upper and lower verticality error does not exceed 2 mm. If it is found that it is not vertical, cement mortar can be used for leveling.
3. Prepare before laying-It is strictly prohibited to soak in water before laying, and conduct an appearance inspection before pasting. Brick arrangement and division are carried out according to design requirements and construction template, and the whole brick should be used for arranging bricks.
4. Laying and pasting wall tiles-After the cement mortar is completely dried, use a jig-shaped knife scraper to evenly apply a special adhesive for wall tiles with a thickness of no more than 3 - 5mm on the wall surface. Before pasting the bricks for the second time, there must be no powder on the surface.
5. Paving details: Paving order, from bottom to top, from inside to outside, use a frame of ≥2mm to leave gaps between the tiles. After the tiles are laid on the wall, rub it left and right, and place the spacing crosses. straighten the frame and gently tap the surface with a rubber hammer to stabilize and ensure 100% fit between the tiles and the base surface.
6, such as construction on the non-cement base layer, you can use the corresponding structural adhesive or epoxy adhesive.
7, daily cleaning, please use water soap or neutral weak acid non-irritating detergent
