1. Fireplace Recess Preparation: Pre-plan the recess and power supply. The decorative finish around the fireplace must meet moisture-resistant and anti-reflective requirements to ensure proper operation. Crucially, the recess must be a self-contained space — it cannot connect with the cavity behind a feature wall or ceiling void. This prevents downdrafts created by HVAC or fresh-air systems, which can disrupt the flame effect. 2. No additional access panel, air intake, or ventilation grille is required for this model. 3. Continuous airflow interferes with the flame pattern. Do not position the fireplace near windows or doors that create drafts, or in the direct path of air-conditioning vents, fresh-air outlets, or similar airflow sources. 4. The fireplace comes with a front glass panel (height: 150 mm). Glass support brackets, fixing screws, and the glass itself are included in the accessories. Pre-drilled holes for the glass brackets are provided on the front panel at the factory; no additional on-site allowance for glass installation is needed. 5. For room-divider installations, a rear glass panel is recommended as an optional extra. 6. Use only purified or filtered water as fuel; do not use tap water. 7. The fireplace is supplied with a standard 220V, 10A three-pin plug and a 1.5 m power cord. The power outlet position is at the lower right-hand side (when facing the fireplace). Ensure the socket is located within reach of the cord during rough-in to avoid on-site alterations.